 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
munch
Level 5 User
Joined: 04 Jul 2006
Posts: 113
|
| Posted:
Thu Jul 20, 2006 3:55 am |
|
Hi peeps need to make myself a good hub puller as i have purchased some of the claw type jobbies and they are crap and couldnt pull the skin off a rice pudding. Its needed to pull off the rear drums on my R5 and also the hubs at the front as i need to do a wheel bearing to, so i need to make something that the wheel nuts fit through and obviously the big bolt through the middle to pull the bugger off. Any ideas on materials needed please and best way to attack the project.
I know they are available to buy but for what they are £20+ is a bit steep
OR. If someone would like to make me one i will cross your palm with silver.
Thanks
Steve |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Thu Jul 20, 2006 4:01 am |
|
leave the wheel on the drun and pull it off.
To get the hub flange out you hit it from the back with a hammer and drift then grind the inner race off it. |
|
|
|
|
munch
Level 5 User
Joined: 04 Jul 2006
Posts: 113
|
| Posted:
Thu Jul 20, 2006 4:08 am |
|
Nice one Chris i will try that later and let you know how it goes. still could do with a hub puller though.
Thanking you
Steve |
|
|
|
|
|
|
| |