 |
|
| Hello, you are currently browsing to Retro-Renault Archive which is a copy of our old forum. You cannot post replies in this forum. Please click here to go to the active website.
|
| Author |
Message |
Bridges
Level 3 User
Joined: 13 May 2004
Posts: 79
|
| Posted:
Wed Jan 05, 2005 12:34 pm |
|
Does anyone know where the washer motor relay is on a phase 1 clio 16v. Am guessing relay because fuse, washer motors and switch are fine.
cheers. |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Wed Jan 05, 2005 12:56 pm |
|
its run through the wiper timer. So if the wipers are ok chances are the relay is fine. check the wiring.
I assume you have tested the motor with a direct feed?
Try another wiper stalk, fiver from a scrappy. |
|
|
|
|
Bridges
Level 3 User
Joined: 13 May 2004
Posts: 79
|
| Posted:
Thu Jan 06, 2005 6:48 am |
|
hot wired straight to the battery and the washer pumps worked fine. Also changed the stalk from a scrappy. No joy, unless the new one is faulty also. Will investigate the wiring today if I get time. This is a damage repairable, we have put in new rear quarter. So far I have no front or back washers and no rear window wiper. Hot wired rear wiper motor and its fine. does this shed any light. Cheers Chris. |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Thu Jan 06, 2005 7:33 am |
|
not really maye, just says to me its a fault with something thats common to them all. Stalk I suppose.
Look at the wiring though, might be melted or split etc |
|
|
|
|
Bridges
Level 3 User
Joined: 13 May 2004
Posts: 79
|
| Posted:
Fri Jan 07, 2005 11:56 am |
|
Had a look at the wiper switch connector today. 1 of the posotive feeds going in was dead. Traced it back to a broken wire, cut out the damadged section and replaced with a nice shiny new bit. Jobs a good un.
Cheers Chris. |
|
|
|
|
Chris H
Forum Moderator
Joined: 02 Mar 2004
Posts: 19978
|
| Posted:
Fri Jan 07, 2005 12:00 pm |
|
|
|
|
|
|
| |