Search found 80 matches

1) Check all engine mounts for play.
2) Strut top mounts, bearings or rubber donut. Also check lower balljoints on wishbones for play.
3) Check correct cable has been fitted (presuming it is a new o ...

Yeah that makes perfect sense.

Thanks Chris

Thanks Chris, just checked the servo and that's fine Very Happy

How do I lock the bias valve open?

Cheers

Cheers mate.

Got braided on there and they are all fine.

I have a new master cylinder to go on, as I think the one that the garage used might not have been the right one, the metal bracket that goes around the ...

A thankyou Very Happy

I'm having some issues with my brakes at the moment, they are terrible and have been since the master cylinder was replaced last year after going in a big way and I wanted to get clu ...

Where does the non-servo end attach to?

Thanks

James

I use Slick 50 in mine and it quietened it down loads.

All of the Clio 16vs/Williams leak fluid from the top of the cap through the bleed hole. I rigged up some tubing that runs from the top of the ...

Most parts available

PM me for details

Cheers

James

Mine took just over 5 (incl filter)

Got stuck for 3 hours with the trains tonight, so haven't been round my parents to take pictures as I'm knackered, cold and thoroughly fucked off!

I'll do them tomorrow night.

Sorry man.

I'll take one of my old 16v engine for you, you'll be able to see where it goes.

I'll post it up tomorrow night.

Does the car sit level?

Are the shocks leaking at all?

Depends, the bearings might be alright.

When I replaced my suspension, I did get both parts, but that was a personal choice.

The MAP sensor connected via a small bore vacuum hose that comes of the end of a hard piece of pipe that is bolted to 2 of the cambelt cover fixings. The other end of this then goes into the inlet man ...

I've been told that new Willy boxes have the diff bolted in (see Williamsclio site)

The part you want is the rubber donut. This sits directly under the suspension tower at the top of the strut.

You can get it from GSF, part number R45714, Â£8.50 + vat.

FYI, the bearing for the ...

You can get Slick 50 from Halfrauds.

Halfords don't do plusgas anymore. Managed to get mine in a small factors

Change the PS fluid, I use Slick 50 in mine and it is dead quiet now.

With the windscreen, try and get it done though your insurance (I assume you have some), excess is usually about Â£50-60.

Th ...

I'm currently putting a Williams engine into my Clio 16v and the support for the dipstick tube has snapped.

A new tube is only about Â£15 from Renault, so I'm going to fit a new one.

I've remove ...