19 16v Chamade complete or breaking - Retro-Renault

Drizz · 23rd May 2007, 05:33 AM

1992 Chamade
Leather
S/S Exhaust
Modded Engine
Original Alloys
Aftermarket Alloys
Uprated Brakes
B&M Quickshift
Tax till end of June
MOT just expired

£400 drive away or PM for spares requests as if enough interest ill break it.
PX Possible too

Cheers

**Neal** · 23rd May 2007, 05:37 AM

In what way are the brakes 'upgraded'?

Is there any rust or damage on the bonnet?

Drizz · 23rd May 2007, 05:41 AM

Drilled and grooved discs all round and EBC pads
IIRC bonnet is perferct but id have to double check

Angdown · 23rd May 2007, 09:52 PM

Any reason for not moting it again? Cheers, looks pretty solid.

**Chris H** · 23rd May 2007, 09:55 PM

its a ph2, theres no such thing as a solid ph2 in 90% of cases

Drizz · 23rd May 2007, 10:08 PM

Well it didnt fail on rust, it looks very clean. Failed on rear caliper, disc and pads. Not worth doing as it was just a run around...

**Chris H** · 23rd May 2007, 10:11 PM

whats up with the caliper? seized? low effort?

Are the pads actually knakcered? same with the disc? is it just corroded?

Bigfoot · 28th May 2007, 07:50 PM

The car is actually very clean which i was suprised at. Replacing the rear calipers, discs as they have cracks in them, and pads seem a bit low on the one side which the caliper has seized on. Supposed to be new pads so unsure on this. Car should go through the MOT end of week and hopefully will pass fine.

If you hadn't have guessed I bought the car off Drizz

23rd May 2007, 05:33 AM	#1 (permalink)
Drizz Membre de bébé Join Date: May 2007 Location: Braintree Posts: 7	19 16v Chamade complete or breaking 1992 Chamade Leather S/S Exhaust Modded Engine Original Alloys Aftermarket Alloys Uprated Brakes B&M Quickshift Tax till end of June MOT just expired £400 drive away or PM for spares requests as if enough interest ill break it. PX Possible too Cheers

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

23rd May 2007, 05:41 AM	#3 (permalink)
Drizz Membre de bébé Join Date: May 2007 Location: Braintree Posts: 7	Drilled and grooved discs all round and EBC pads IIRC bonnet is perferct but id have to double check

23rd May 2007, 09:52 PM	#4 (permalink)
Angdown Membre Join Date: May 2007 Posts: 52	Any reason for not moting it again? Cheers, looks pretty solid.

23rd May 2007, 10:08 PM	#6 (permalink)
Drizz Membre de bébé Join Date: May 2007 Location: Braintree Posts: 7	Well it didnt fail on rust, it looks very clean. Failed on rear caliper, disc and pads. Not worth doing as it was just a run around...